|Search||Hot Links||What's New!|
Please let me remind all of you--this
material is copyrighted. Though partially funded by NASA, it is still a private
site. Therefore, before using our materials in any form, electronic or otherwise, you need
to ask permission.
There are two ways to browse the site: (1) use the search button above to find specific materials using keywords; or,
(2) go to specific headings like history, principles or careers at specific levels above and click on the button.
Teachers may go directly to the Teachers' Guide from the For Teachers button above or site browse as in (1) and (2).
Aircraft Hydraulics is a means of transmitting energy or power from one place to another efficiently.
is a system where liquid under pressure is used to transmit this energy. Hydraulics
systems take engine power and converts it to hydraulic power by means of a hydraulic pump.
This power can be distributed throughout the airplane by means of tubing that runs through
the aircraft. Hydraulic power may be reconverted to mechanical power by means of an
actuating cylinder, or turbine.
(1) - A hydraulic pump converts mechanical power to hydraulic power
(2) - An actuating cylinder converts hydraulic power to mechanical power
(3) - Landing Gear
(4) - Engine power (mechanical HP)
If an electrical system were used instead of a hydraulic system, a generator would take the place of the pump and a motor would take the place of the actuating cylinder.
(over other systems for aircraft use)
Example: A gun turret must be able to change direction
almost instantaneously. This is what is accomplished by this hydraulic system. In an
electrical system, the rotating armature must come to full stop and then reverse direction
or else the armature will burn out. This doesn't happen with a hydraulic system because
there is no need for a motor in the hydraulic system.
Example: In a landing gear the hydraulic motor can produce enough power to pull up the landing gear system without trouble even though air loads act on the system and the slip stream air is impinging against it.
The actuating cylinder can change hydraulic power to linear or rotating motion. It has a reduction gear in it to reduce rotating motion to that amount which is needed. Previously, systems used to control motion by using steel cables connected by pulleys between the controlling mechanism (such as the pedals) and the controlled surface (such as the rudder). The cables were affected by expansion rates of the cables due to temperature changes. Hydraulic systems can control motion without worrying about the effect of temperature since it is a closed system (not open to the atmosphere) compared to a cable system. This means better control of the plane and less lag time between the pilot's movement to control the plane and the response by the control surface.
Send all comments to firstname.lastname@example.org
© 1995-2017 ALLSTAR Network. All rights reserved worldwide.
Updated: March 12, 2004